SAFE-O-TRONIC® accessItem No.: 231.98.000/001/002/003Mounting InstructionsDimensions in mmInches are approximateElectronic Identification and Locking S
10OperationOperation is supported by the red/green LED display and an acoustic acknowledgement by means of signal transmitters. The key c
11For initial operation every SAFE-O-TRONIC® LS 100 lock has to be programmed using MasterCode2. Please note: Please make sure that unauthorized pe
12Locking and opening using MasterCode2The operator of the facility can use MasterCode2 at any time to open or lock the locker fitted with the SAFE-O-T
13Altering MasterCode2 Press the OK and abort keys simultaneously and Enter active MasterCode2 Notice: 3, 5,
14Programming MasterCode1MasterCode1 is not activated in the factory and must be programmed by the operator. Notice: An identical code for Mast
15Opening using MasterCode1After programming, a locker can be opened with the help of MasterCode1. Enter MasterCode1 Then press the O
16LED Display All important actions and operating conditions are indicated by the LED display and are intended to contribute to finding the causes of f
17You are able to see errors and operating errors in the status messages of the LED display and then correct them accordingly.Reset should be carried
18Indicators: 2 x LED green 2 x LED redAcoustic signal: Signal transmitterBattery: Battery pack: 3 x alkaline cells (AAA)Batter
3901 Cheyenne DriveP.O. Box 4000Archdale, NC 272631-800-423-3531www.hafele.comFurther Functions Notice: Depending on the printer there can be dimensi
2 ® Copyright 2010 by Schulte-Schlagbaum AG Nevigeser Straße 100-110 D-42553 Velbert Phone: +49 2051 2086-0 http:/www.sag-schla
3Notes on this manual... 2Safety and warning notes...
4LED display red / greenCapacity keypadExchangeable plateRotary knob OK key: Finish of Code entry Abort key: Code entries or programm
5Lock with Mounting Components1 Lock 2 Nut for mounting the lock on the door 3 Grommet for setting the rotational direction of the rotary knob in o
6Preparation of the doorThe following holes must exist in the door corresponding to the drawing: 1. Punched hole, dimensions 19.1 mm / 16 mm. A roun
7Installation InformationSettng the rotational direction for lockingThe setting of the rotational direction described here is for a lock with a rotary
8Installation InformationReplacing the plate (e.g. for numbers, logo, etc.)After inserting a small screwdriver into the center of the plate, the old p
9Capacitive keypadThe SAFE-O-TRONIC® LS 100 uses a capacitive keypad. Notice: The capacitive keypad cannot be operated if you are wearing gloves.
Comments to this Manuals